Elsner KNX T-UP Touch handleiding

46 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 32 van 46
30 Parameter setting
Sensor KNX T-UP Touch • Version: 05.09.2022 • Technical changes and errors excepted.
Enter the hysteresis that prevents frequent on/off switching of temperatures in the
threshold range.
If separate control variables are used, select whether the control variable of the 2nd
level is a 1 bit object (on/off) or an 8 bit object (on with percentage/off).
Now specify what should be sent when the control is blocked.
On release, the control variable follows the rule again.
In case of a common control variable for heating and cooling, 0 is always transmitted
as a fixed value.
6.6. Variable comparator
The two integrated control variable comparators can output maximum, minimum and
median values.
6.6.1. Control variable comparator 1/2
Determine what the control variable comparator should output, and activate the input
objects to be used. Send behaviour and blocks can also be set.
Control type
is determined at a higher level for common
variables
2-point-control
Hysteresis (in 0.1°C) 0...100; 20
Control variable is a • 1 bit object
• 8 bit object
Value (in %)
(for 8 bit object)
0...100
When blocked, the control variable shall • not be sent
• send a specific value
Value (in %)
(if a value is sent)
0...100
Use comparator 1/2 No • Yes
Output delivered Maximum value
Minimum value
Average value
Use input 1/2/3/4/5 No • Yes
Output sends on change of output
on change of output and periodically
when receiving an input object
when receiving an input object and peri-
odically
From change of
(is only sent if "on change" is selected)
1% • 2% • 5% • 10% • 20% • 25%

Bekijk gratis de handleiding van Elsner KNX T-UP Touch, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkElsner
ModelKNX T-UP Touch
CategorieNiet gecategoriseerd
TaalNederlands
Grootte4147 MB