Elsner Corlo Touch KNX 5in WL handleiding
Handleiding
Je bekijkt pagina 58 van 144
56 System settings via touch display
Display Corlo Touch KNX 5in • Status: 30.08.2021 • Technical changes and errors reserved.
2.10.4.Addressing the equipment
The programming mode for addressing at the bus is activated via the programming
button at the back of the housing or via the display.
Settings > System > Service > KNX
2.10.5.Info
This is where you can find the KNX software version information, the display software
version and the operating system software version.
Settings > system > service > info
2.10.6.License
Here you can find information about the licenses for software and hardware
components used in the Display Corlo Touch KNX 5in as well as license documents
and license holders.
KNX programming LED ON:
Programming mode active.
KNX programming LED OFF:
Programming mode off.
The current address is displayed (Address
15.15.250 when delivered).
Bekijk gratis de handleiding van Elsner Corlo Touch KNX 5in WL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Corlo Touch KNX 5in WL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 17270 MB |
