Elsner Cala Touch KNX TH handleiding
Handleiding
Je bekijkt pagina 82 van 118
80 Setting the parameters and functions for all
Room Controller Cala Touch KNX • Version: 13.07.2022 • Technical changes and errors excepted.
Standard inverted:
When pushed shortly, the drive moves up to the end position. When pushed for longer,
the drive moves incrementally or stops. The time difference between "short" and
"long" and the repeat interval is set individually.
Comfort mode:
In the comfort mode actuating the button briefly, a bit longer and long will trigger dif-
ferent responses of the drive. The time intervals are set individually.
Short actuation (shorter than Time 1): The drive is positioned step-wise and stopped.
Holding it slightly longer (longer than Time 1, but shorter than Time 1+2): Drive run-
ning. Drive stops when the button is released.
Long holding (release after Time 1+2 runs out): Drive moves independently to the end
position. The movement can be interrupted by a short tap.
Control mode Standard inverted
Behavior during button operation:
short = Up or Down long = Stop/Step
Time between short and long
in 0.1 seconds
1...50; 10
Repeat the step command
for a long button press
every 0.1 s • every 2 sec; every 0.5 sec
Point in time 0: Actuate of button, start of time 1
Release before time 1 expired: step (or stop if drive is moving)
Point in time 1: End of time 1, start of time 2
Moving command
Release after time 1 expired
but before time 2 expires: Stop
Release after time 1 + 2 expired: Move into end position
Control mode Comfort mode
Behavior during button operation:
Button is pushed and
released before time 1 expired = stop/step
held longer than time 1 = Up or Down
released between time 1 and 1-2= stop
released after time 1 +2 = no more stop
Time 1 0.0s ... • 2 s; 0.4 s
Time 2 0 s • 2 s; 2 s
Time 1 Time 2
01 1 + 2
Fig. 33
Time interval comfort mode diagram
Bekijk gratis de handleiding van Elsner Cala Touch KNX TH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Cala Touch KNX TH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11667 MB |
