Elsner Cala Touch KNX TH handleiding
Handleiding
Je bekijkt pagina 115 van 118
113 CO
2
parameter settings
Room Controller Cala Touch KNX • Version: 13.07.2022 • Technical changes and errors excepted.
The status object shows the current status of the output variable (0 = OFF, >0 = ON) and
can for example be used for visualisation.
Controller setpoint
The setpoint values can be set directly in the application program using parameters, or
be defined via the bus using a communication object.
Setpoint value setting using parameters:
Set the setpoint value directly.
Setpoint value setting via communication object:
Enter, how the setpoint value will be received from the bus. Basically, a new value can
be received, or simply a command to increase or decrease.
During initial commissioning, a setpoint value must be defined which is valid until the
first communication of a new setpoint value. For units which have already been taken
into service, the last communicated setpoint value can be used. Basically, an air humid-
ity range is given in which the setpoint value can be changed (object value limit).
A set setpoint value will be retained until a new value or a change is transferred. The
current value is saved, so that it is retained in the event of a power supply failure and
will be available once the power supply is restored.
at and above change of (in ppm) 1...20; 2
Cycle
(if sent periodically)
5 s • ... • 5 min • … • 2 h
Send status object(s) • on change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
Cycle
(if sent periodically)
5 s • 10 s • … • 2 h
Specified setpoint using Parameter • Communication objects
Target value in ppm 400…5000; 800
Threshold value setting using Parameter • Communication objects
The last communicated value should be
retained
• never
• after power supply restoration
• after power supply restoration and
programming
Start setpoint value in ppm
valid until first communication
(not upon saving the setpoint value after
programming)
400… 2000; 800
Bekijk gratis de handleiding van Elsner Cala Touch KNX TH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Cala Touch KNX TH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11667 MB |
