Handleiding
Je bekijkt pagina 37 van 44
User Manual
–
IDS ET320
4
L/ET430
4
L/505
4L/5554L/6554L
UM6
00721
Rev
.
A
page
37
of
44
Notice to Users in Canada:
This equipment complies with the Class A limits for radio noise emissions from digital
apparatus as established by the Radio Interference Regulations of Industrial Canada.
CAN ICES3(A)/NMB3(A)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with
the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for
emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which
means that the equipment has been tested to the following Directives and Standards: This equipment has been
tested to the requirements for the CE Mark as required by EMC Directive 2014/30/ EU as indicated in European
Standard EN 55032 Class A and the Low Voltage Directive 2014/35/EU as indicated in European Standard EN
60950-1.
General Information to all Users: This equipment generates, uses and can radiate radio frequency energy. If not
installed and used according to this manual, the equipment may cause interference with radio and television
communications. There is, however, no guarantee that interference will not occur in any particular installation due to
site-specific factors.
1. In order to meet emission and immunity requirements, the user must observe the following:
a. Use only the provided I/O cables to connect this digital device with any computer.
b. To ensure compliance, use only the provided manufacturer’s approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
2. If this equipment appears to cause interference with radio or television reception, or any other device:
a. Verify as an emission source by turning the equipment off and on. If you determine that the equipment is
causing the interference, try to correct the interference by using one or more of the following measures:
Bekijk gratis de handleiding van ELO E104520, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ELO |
| Model | E104520 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 8155 MB |
