Elna 864air handleiding
Handleiding
Je bekijkt pagina 56 van 64
54
Replacing the Upper Knife
To remove:
z
Open the looper cover.
x
Turn the handwheel toward you until the upper knife
reaches its highest position.
c
Remove the hexagonal bolt with the double-ended
spanner (use the small end) and remove the upper
knife.
q
Upper knife
w
Hexagonal bolt
e
Double-ended spanner (small end 5.5 mm)
To attach:
z Attach the new upper knife to the upper knife
supporter and partially tighten the hexagonal bolt.
q Upper knife
w Hexagonal bolt
r Upper knife supporter
x Turn the handwheel toward you until the upper knife
reaches its lowest position.
c Loosen the hexagonal bolt.
Adjust the position of the upper knife so that its blade
overlaps 1.0 mm to 1.2 mm (3/64˝) with the edge
of the lower knife as shown, and fully tighten the
hexagonal bolt.
t Lower knife
y 1.0 – 1.2 mm (3/64˝)
v Turn the handwheel toward you several times to check
the blade position.
b Close the looper cover.
CAUTION
Make sure to turn the power switch off before
replacing the upper knife.
q
w
e
z x c
q
w
t
r
y
z x c v b
Bekijk gratis de handleiding van Elna 864air, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elna |
| Model | 864air |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 7726 MB |
