Elica NikolaTesla PRIME S / PRIME S+ PRF0186751 handleiding

Fornuis

Elica

368 pagina's

PDF beschikbaar

Handleiding

/ 368

Je bekijkt pagina 20 van 368

Activation:

• press (9), the symbol will flash on the display (2)

To deactivate the function:

• press (9) the Selection bar (3) will light up

• press/slide on the Selection Bar (3) to deactivate the

function.

Note: deactivation restores the conditions of the hob before

the pause; the hob continues to work with the same

settings previously set.

Note: if after 10 minutes, the Pause Function is not

deactivated, the hob will turn off automatically.

Note: the Pause Function does not affect the extraction.

● “STAND ALONE” Timer

The Timer function is a countdown independent of the

cooking zones (and the extraction zone).

The Timer is activated by pressing the Zone/Display (4).

Use the symbols (5) to set the duration of the

Timer, which is shown in the Zone/Display (4)

Note: wait 10 seconds without pressing any other

command, so that the countdown starts.

The Timer can be set up to a maximum of 1(h) and

59(min.) The Zone/Display (4) will show the remaining

time; an acoustic signal will be emitted at the end of the

countdown.

Note: When the remaining time is less than 10 minutes, a

fixed dot will appear in the timer after the first number.

Displayed value Remaining time

1h and 35 min

1min. and 35 sec.

To switch off the Timer:

• select Zone/Display (4)

• set the duration of the Timer to Zero , using

(5)

● Temperature Manager (Warming Function)

Temperature Manager is a control function that allows the

maintaining of heat at a constant temperature, at an

optimised power level; ideal to keep ready-cooked foods

warm. The Temperature Manager function is activated the

first time the key (8) is pressed.

The symbol appears in the display (2) of the zone that is

working in the Temperature Manager

Note: by selecting another cooking zone at the same time,

the symbol (8) will go back to being illuminated with

light intensity, and it will be possible to proceed, also for

this zone, with the activation of the function; in any case,

the function remains active in the zone in which it has

already been set, as indicated in the Display (2).

• Press (8) again to deactivate and switch off, until the

level shown in the Display (2) is brought to .

Note: if there are several zones operating in Temperature

Manager (Warming Function) mode, select the desired

zone first using the Selection zone (2); the function can

also be deactivated using the Selection bar (3), by

bringing the Power Level to .

USING THE EXTRACTOR

● Switching the extraction system on:

• Switch on the hob as indicated in the “Power-on” chapter

on “using the hob”;

● Extraction speed (power):

The extractor has 4 speed (power) levels from to ,

Touch and slide your fingers along the Selection bar (3):

to the right to increase the power level, to the left to

decrease the power level.

Note: The set power level will be displayed in the

Selection/Display area (12)

● Power Booster

The extractor is equipped with 1 additional extraction level

called Power Booster; it is timed and it lasts 5 minutes.

To select it, touch and slide your fingers along the

Selection bar (3) (beyond the level ); this flashing

symbol will be displayed: .

Note: after the five minutes, the power will go back to the

previously set level.

● Automatic mode

The hood will turn on at the most suitable speed, adapting

the extraction capacity to the maximum cooking level used

in the cooking zones.

When the cooking zones are switched off, the hood adapts

its extraction speed, decreasing it gradually, to eliminate

residual vapours and odours.

To activate this function:

Press (14);

Repeat the operation to deactivate.

Note: if, during automatic operation, the speeds from to

are selected using the Selection bar (3), automatic

operation is interrupted; if, on the other hand, the Power

Booster is selected, automatic operation will resume at the

end of the timer and, in the meantime, the symbol

keeps flashing.

Note: if the hob automatically shuts down with Automatic

/ 368

Bekijk gratis de handleiding van Elica NikolaTesla PRIME S / PRIME S+ PRF0186751, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.