Elektron Tonverk handleiding
Handleiding
Je bekijkt pagina 92 van 110
APPENDIX A: MACHINES
92
SPD
Speed sets the speed of the pitch motion. A parameter value of 0 gives a constant pitch, negative
values result in increasingly quick downward motions, and positive values result in increasingly quick
upward motions.
DEP
Depth sets the intensity of the flanging eect.
TUNE
Downtune adjusts the tuning of the delay line progressively downward, from true flanging to sounds
that resemble comb filtering, and finally to audible delay.
FDBK
Feedback sets the amount of output signal fed back into the delay line.
LPF
Feedback Filter Cuto sets the cuto frequency of a low-pass filter placed in the feedback loop.
A.3.11 LOW-PASS FILTER
This is a 4-pole, 24 dB/octave slope low-pass filter with internal modulation and stereo width controls.
SPD
LFO Speed sets the speed of the built-in LFO. It is tempo-synced, and the values are measured in
sequencer steps.
DEP
LFO Depth sets the amount of frequency modulation applied from the LFO to the filter.
SPH
LFO Start Phase sets the triggering behavior of the LFO. The parameter value OFF indicates that it
will run free. Other values will cause the LFO to retrigger from that phase position every time a note is
played on the track.
LAG
LFO Phase Oset osets the LFO’s phase in the right and left channels.
FREQ
Cuto Frequency sets the cuto frequency of the filter.
RESO
Resonance sets the resonance behavior of the filter. Resonance introduces a peak in the spectrum at
the cuto frequency.
Bekijk gratis de handleiding van Elektron Tonverk, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elektron |
| Model | Tonverk |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15555 MB |