Electrolux WTSL6IE501 handleiding
Handleiding
Je bekijkt pagina 40 van 224
• Remove the inlet hose behind the appliance.
• Clean the filter in the valve with a stiff brush or
a towel.
45°
20°
• Install again the inlet hose. Make sure that the
couplings are tight to prevent leakages.
• Open the water tap.
15.12 Emergency drain
If the appliance cannot drain the water, carry
out the same procedure, described in
'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water.
15.13 Frost precautions
If the appliance is installed in an area where
the temperature can reach the values around
0° C or drop below, remove the remaining
water from the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install the
inlet hose again.
40 ENGLISH
Bekijk gratis de handleiding van Electrolux WTSL6IE501, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | WTSL6IE501 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 21821 MB |
