Electrolux WH6-20LAC handleiding
Handleiding
Je bekijkt pagina 15 van 32
Installation manual
15
5 Water connection
All water intake connections to the machine should be fitted with manual shut-off valves and filters, to facilitate instal-
lation and servicing.
Water pipes and hoses should be flushed clean before installation.
The machine shall be connected with new water hoses. Re-used water hoses must not be used.
Hoses are to be of an approved type and grade and comply with IEC 61770 and any applicable local regulations.
After installation hoses must hang in gentle arcs.
All connectors present on the machine must be connected. The table shows the possible connection options, which
will depend on the water types to be connected to the machine. Information is also available on the panel above the
connections.
Water type Water connection
1
2
3
• Cold and hot 1. Cold
2. Hot
3. Cold (for detergent dispenser) / Hot
Remove the three plastic covers (A).
A
fig.7811B
Note!
For unheated machines with Lagoon Advanced Care programs, the programs requires pre heating (25℃) for
the cold water valves.
Note!
The inlet temperature for cold water must not be higher than 25℃. If so, a water cooling system must be
installed.
Bekijk gratis de handleiding van Electrolux WH6-20LAC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | WH6-20LAC |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 2613 MB |
