Electrolux UltimateCare 500 ESF6604XB handleiding

Niet gecategoriseerd

Electrolux

28 pagina's

PDF beschikbaar

Handleiding

EN - 9

4. BEFORE USING THE

APPLIANCE

4.1. Detergent usage

Only use detergents specifically designed

for domestic dishwashers. Keep your

detergents in cool, dry places out of reach

of children.

Add the proper detergent for the selected

program to ensure the best performance.

The amount of detergent needed depends

on the cycle, load size, and soil level of

dishes.

Do not fill detergent into the detergent

compartment more than required; otherwise

you can see whitish streaks or bluish layers

on glass and dishes and may cause glass

corrosion. Continued use of too much

detergent may cause machine damage.

Using little detergent can result in poor

cleaning and you can see whitish streaksin

hard water.

See the detergent manufacturer’s

instructions for a further information.

4.2. Filling the detergent

Push the latch to open the dispenser and

pour in the detergent.

Close the lid and press it until it locks in

place. The dispenser should be refilled just

before the start of each program. If the

dishes are heavily soiled, place additional

detergent in the pre-wash detergent

chamber.

DETERGENT

4.3. Using combined detergents

These products should be used according

to the manufacturer’s instructions.

Never put combined detergents into the

interior section or the cutlery basket.

Combined detergents contain not only

the detergent but also rinse-aid

replacement substances and additional

components depending on the combination.

We recommend you do not use combined

detergents in short programs.

Please use powder detergents in such

programs.

If you encounter problems when using

combined detergents, please contact the

detergent manufacturer.

When you stop using combined detergents,

make sure that rinse aid setting is set to

correct level.

4.4. Rinse-aid usage

The rinse aid helps to dry the dishes

without streaks and stains. Rinse-aid is

required for stain-free utensils and clear

glasses. The rinse aid is automatically

released during the hot rinse phase. If

rinse aid dosage setting set too low, whitish

stains remains on dishes and dishes do not

dry and washed clean.

If rinse aid dosage setting set too height,

you can see bluish layers on glass and

dishes.

4.5. Filling the rinse-aid and setting

To fill the rinse aid compartment, open

the rinse-aid compartment cap. Fill the

compartment with rinse aid to the MAX

level and then close the cap. Be careful not

to overfill the rinse aid compartment and

wipe up any spills.

In order to change the rinse aid level,

follow the below steps before turning on

the machine:

• Turn on the machine by pressing the

On/Off button.

• Press the Up button for at least

3 seconds immediately after the

machine is turned on.

• Release the Up button when all leds

blinks once. The last setting level is

displayed.

• Press Up or Down button to increase or

decrease the hardness level.

• Turn off the machine to save the setting.

The factory setting is “4”.

If the dishes are not drying properly or are

spotted, increase the level. If blue stains

form on your dishes, decrease the level.

Bekijk gratis de handleiding van Electrolux UltimateCare 500 ESF6604XB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.