Electrolux KIS82453I handleiding
Handleiding
Je bekijkt pagina 21 van 124
Problem Possible cause Remedy
Residual heat indicator does not
come on.
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Hob²Hood does not work. You covered the control panel. Remove the object from the control
panel.
You use a very tall pot which blocks
the signal.
Use a smaller pot, change the cooking
zone or operate the hood manually.
The control panel becomes hot to
the touch.
The cookware is too large or you put
it too close to the control panel.
Put large cookware on the rear zones,
if possible.
There is no sound when you
touch the panel sensor fields.
The sounds are deactivated. Activate the sounds. Refer to "Daily
use".
The indicator above the symbol
comes on.
Child Safety Device or Lock oper‐
ates.
Refer to "Child Safety Device" and
"Lock".
The control bar blinks. There is no cookware on the zone or
the zone is not fully covered.
Put cookware on the zone so that it
fully covers the cooking zone.
The cookware is unsuitable. Use cookware suitable for induction
hobs. Refer to "Hints and tips".
The diameter of the bottom of the
cookware is too small for the zone.
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Heating up takes a long time. Cookware is too small and receives
only a part of the power generated
by the cooking zone.
For optimal heat transfer use cook‐
ware with bottom diameter similar to
the size of the cooking zone (i.e. the
maximum cookware diameter value in
"Technical data" > "Cooking zones
specification").
and appear simultane‐
ously.
The power is too low due to unsuita‐
ble cookware or an empty pot.
Use the appropriate type of cookware.
Refer to "Hints and Tips" and "Techni‐
cal Data".
Do not activate any zone with an emp‐
ty pot on it.
and appear simultane‐
ously.
The pot is empty or contains some
liquid other than water, e.g. oil.
Avoid using the function with liquids
other than water.
and appear simultane‐
ously.
There is too much or too little water
in the pot.
You boiled some food other than wa‐
ter and potatoes. The boiling point
was moved in time and SenseBoil®
could not work properly.
Only boil water and potatoes with the
use of SenseBoil®. Refer to "Hints and
Tips".
You hear a beep sound, the indi‐
cators above blink and
SenseBoil® does not start.
None of the cooking zones is ready
to be used with SenseBoil®. There
is some residual heat on the cooking
zones you want to choose or they
are still in use.
Finish your previous cooking activities
and choose a free cooking zone with‐
out any residual heat.
ENGLISH 21
Bekijk gratis de handleiding van Electrolux KIS82453I, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | KIS82453I |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 11177 MB |
