Electrolux EWI754RY6G handleiding
Handleiding
Je bekijkt pagina 86 van 336
Refresh programme can be selected in
the SmartSelect area.
The indicator of the Start/Pause button
flashes.
The display shows an indicative programme
duration, the maximum declared load for the
set programme (only for a few seconds), the
default temperature, the default spin speed
and the washing phase indicators (when
available).
2. Use the SmartSelect function to change
the soil level. The appliance automatically
recommends the lowest temperature and
the optimal settings combination to
achieve the right result in the shortest
time. Steam Refresh programme can be
selected in the SmartSelect area
3. To change the temperature and/or the
spin speed, touch the related buttons.
4. If desired, set one or more options by
touching the related buttons. The related
indicators come on in the display and the
given information changes accordingly.
In case a selection is not possible an
acoustic signal sounds.
12.6 Starting a programme
Touch the Start/Pause key button to start
the programme.
The related indicator stops flashing and stays
on.
The programme starts, the door is locked.
The display shows the indicator .
The drain pump can operate shortly
before the appliance fills water.
12.7 Starting a programme with the
Finish In
1. Touch this repeatedly until the display
shows the desired time within the
programme should end. The indicator
comes on.
2. Touch the Start/Pause
key button.
The drum starts rotating to perform the
SensiCare estimation, if foreseen in the
selected programme.
3. The appliance starts the countdown to the
end of the programme and the
programme will start at the right moment
for ending at the time set through this
option.
To change or cancel this option:
1. Switch the appliance off by means of the
On/Off button.
2. Switch the appliance on again.
3. Set the programme again.
12.8 The SensiCare System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause key
button, the maximum declared load indicator
goes off, the SensiCare System starts the
laundry load detection:
1. The appliance detects the load in the first
30 seconds. During this phase scrolling
dashes play a simple animation. If
overloading is detected, the overloading
info will show for 30s before the display
goes in the previous view.
2. During this phase the drum rotates
shortly.
3. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
key button to start
the programme again. The SensiCare phase
can be repeated up to three times (see point
1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
86 ENGLISH
Bekijk gratis de handleiding van Electrolux EWI754RY6G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EWI754RY6G |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 31982 MB |
