Electrolux EWF1042R9SC handleiding
Handleiding
Je bekijkt pagina 55 van 64
ENGLISH 55
17.10 Frost Precautions
17.9 Emergency Drain
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the main plug from the
main socket.
2. Close the water tap.
3. Remove the water inlet hose.
4. Remove the drain hose from the rear
support and unhook it from sink or
spigot.
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph.
If necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main
wash compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
5. Put the end of the drain and inlet hose
in a container. Let the water flow out
of the hoses.
6. When no more water flows, install the
inlet hose again.
Make sure that the temperature
is more than 0 °C before you use the
appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
Bekijk gratis de handleiding van Electrolux EWF1042R9SC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EWF1042R9SC |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 6213 MB |
