Electrolux EW7F39 handleiding
Handleiding
Je bekijkt pagina 23 van 76
If a selection is not possible an acoustic
signal sounds and the display shows
.
10.6 Additional information about
daily use
The SensiCare System load detection
The SensiCare System adjusts automatically
the programme duration to the laundry in the
drum to achieve perfect washing results in
the minimum possible time. The appliance
detects the load in the first 30 seconds. In the
programmes where Time Manager is
available, during this phase the display play a
simple animation. The drum rotates shortly.
At the end of the load detection, in case of
drum overload, the indicator is
flashing in the display. You can pause the
appliance and remove the exceeding
garments. If not the washing programme
starts anyway. About 20 minutes after the
programme start, the programme duration
could be adjusted again depending on the
capacity of water absorption of the fabrics.
The SensiCare System is not available in
programmes with short cycles.
Starting a programme
Touch the Avvio/Pausa button to start the
programme. The related indicator stops
flashing and stays on. The programme starts,
the door is locked. The display shows the
indicator The programme starts, the door is
locked. The display shows the indicator .
Starting a programme with delay start
1. Touch the Partenza Ritardata button
repeatedly until the display shows the desired
delay time.
2. Touch the Avvio/Pausa button. The
appliance door locks and starts the
countdown of the delay start. When the
countdown is completed, the programme
starts automatically.
Interrupting a programme and changing
the options.
1. When the programme is running, you can
change only some options. Touch the Avvio/
Pausa button.
2. Change the options. The given information
in the display changes accordingly
3. Touch the Avvio/Pausa
again. The
washing programme continues.
Cancelling a running programme
• Press the button On/Off button to cancel
the programme and to deactivate the
appliance. Press again to activate the
appliance.
• Rotate the selection knob to the "reset"
position activate the appliance . Wait 2
second. Now you can set a new washing
programme.
End of the programme
• The appliance stops automatically. In the
display comes on. The acoustic
signals operate (if they are active).
• The indicator of the Avvio/Pausa button
goes off. The door locked goes off
and the door unlocks.
Thanks to anti-crease phase the appliance
continues to operate with for
approximately 30 minutes or more. The
indicator remains lit. You can remove
the laundry any time.
• Press the On/Off button for some seconds
to deactivate the appliance. Keep the door
and the detergent dispenser slightly ajar to
prevent mildew and odours.
Draining water out after end of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse you must remember to drain the water:
• Touch button Centrifuga to decrease the
spin speed proposed by the appliance
• Press the Avvio/Pausa
• When the programme is completed and
the door locked indicator goes off, you
can open the door.
• On/Off to deactivate the appliance.
ENGLISH 23
Bekijk gratis de handleiding van Electrolux EW7F39, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EW7F39 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 6787 MB |
