Electrolux EW6T462W4W handleiding
Handleiding
Je bekijkt pagina 28 van 172
– powder detergents (also tablets and
single-dose detergents) for all types of
fabric, excluding delicate. Prefer
powder detergents containing bleach
for whites and laundry sanitization,
– liquid detergents (also single-dose
detergents), preferably for low
temperature wash programmes (60 °C
max) for all types of fabric, or special
ones for woollens only.
• Do not mix different types of detergents.
• Use less detergent if:
– you are washing a small load,
– the laundry is lightly soiled,
– there is large amounts of foam during
washing.
• When using detergent tabs or pods,
always put them inside the drum, not in
the detergent dispenser and follow the
manufacturer's recommendations.
Insufficient detergent may cause:
• unsatisfactory washing results,
• the wash load to turn grey,
• greasy clothes,
• mould in the appliance.
Excessive detergent may cause:
• sudsing,
• reduced washing effect,
• inadequate rinsing,
• a greater impact for the environment.
14. ALARM CODES AND POSSIBLE FAILURES
Table title
.
The appliance does not start or it stops during operation. First try to find a solution to the problem
(refer to the tables).
WARNING!
Deactivate the appliance before carrying out any check.
Table title
.
Problem Possible solution
The appliance does not fill
with water properly.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low. For this infor‐
mation, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or bends.
• Make sure that the connection of the water inlet hose is correct.
• Make sure that the filter of the inlet hose and the filter of the valve are not
clogged.
The appliance does not drain
the water.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Make sure that the drain filter is not clogged. Clean the filter, if necessary.
• Make sure that the connection of the drain hose is correct.
• Set the drain programme if you set a programme without drain phase.
• Set the drain programme if you set an option which ends with water in the tub.
Internal fail. No communica‐
tion between electronic ele‐
ments of the appliance.
• The programme was not finished properly or the appliance stopped too early.
Switch the appliance off and on again.
• If the alarm code appears again, contact the Authorised Service Centre.
The mains supply is unsta‐
ble.
• Wait until mains supply is stable.
28 ENGLISH
Bekijk gratis de handleiding van Electrolux EW6T462W4W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EW6T462W4W |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 16094 MB |
