Electrolux EFI953SY6S handleiding
Handleiding
Je bekijkt pagina 61 van 300
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any other
appliances may also be in use.
Connect the appliance to an earthed
socket.
The power supply cable must be easily
accessible after installing the appliance.
For any electrical work required to install this
appliance, contact our Authorised Service
Centre.
The manufacturer does not accept any
responsibility for damage or injury through
failure to comply with the above safety
precaution.
6. THE WATER SOFTENER (COLOURCARE)
6.1 Introduction
The water contains harsh minerals. The
higher the content of these minerals the
harder the water is.
Hard water can reduce the effectiveness of
the detergent, reduce the softness of fabrics
and contribute towards shrinkage and colour
fading.
This appliance is equipped with a water
softener able to provide the right degree of
water softening to preserve the fabric
integrity, colour brightness and ensuring good
wash performances at low temperature.
The water softener should be adjusted
according to the water hardness of your inlet
water. A correct setting allows to achieve the
best washing results and the maximum
garments protection.
To set the water softener correctly, please
refer to 'How to set the water hardness level'.
6.2 How to set the water hardness
level
The appliance allows you to chose between 7
levels corresponding to 7 different ranges of
water hardness.
Depending on the country, the water
hardness is expressed in equivalent scales:
e.g. French degrees (°f), German degrees
(°d), English degrees (°e), mmol/l and ppm.
If necessary, please contact your local water
authority to check the water hardness in your
area.
If you cannot obtain the information by your
local water authority, detect the water
hardness by using the tester supplied with the
appliance documentation.
Check in the "Water hardness levels" table
which is the proper level.
To set the water hardness level:
1. Press the On/Off
button for a few
seconds to activate the appliance.
2. Wait about 10 seconds for appliance
internal check.
3. Hold pressed the Steam Easy Iron and
the Extra Rinse key buttons
simultaneously for a few seconds until the
display shows the default level -4- and
in the display. It means the water
softener is active during washing only.
4. Touch repeatedly the Extra Rinse button
until the desired level appears (from -1- to
-7-).
5. Hold pressed the Steam Easy Iron and
the Extra Rinse key buttons
simultaneously for a few seconds again
and the display returns to the programme
information screen.
ENGLISH 61
Bekijk gratis de handleiding van Electrolux EFI953SY6S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electrolux |
| Model | EFI953SY6S |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 29742 MB |
