Electro-Voice EVA-SG2 handleiding
Handleiding
Je bekijkt pagina 19 van 44
EVA Expandable Vertical Array Preparing modules for installation | en 19
Electro-Voice
Installation manual
2023-01 | 04 | F01U196199
To shade the upper HF element by 3dB:
4 Reinsert the switch card one step higher.
Figure6.2: EVA input panel, with the switch card inserted to shade the upper HF element by 3 dB
To shade the lower HF element:
4 Reinsert the switch card one step lower.
Figure6.3: EVA input panel, with the switch card inserted to shade the lower HF element by 3 dB
Use of optional attenuation modules
Some array designs also use one or more of the optional EVA-AM attenuation modules.
i
Notice!
The EVA-AM is for use only with EVA-2082S full-range modules.
To attach the EVA-AM attenuation modules to the inside of the input-panel assembly:
1. Using a Phillips #2 screwdriver, remove the eight screws holding the input panel in place.
The cable assembly that connects the green PC board of the input panel to the crossover/
equalizer network inside the EVA module is long enough to allow the input-panel
assembly to rest on a flat surface close to the EVA module. If necessary, disconnect the
crossover/equalizer cable temporarily.
Bekijk gratis de handleiding van Electro-Voice EVA-SG2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Electro-Voice |
| Model | EVA-SG2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3734 MB |
