Handleiding
Je bekijkt pagina 5 van 31
Page 5 of 31
storage. This is normal and will quickly disappear.
• This appliance has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or any flammable liquids are used or stored.
• Never locate this appliance where it may fall into a bathtub or otherwise become exposed to
water.
• This appliance is IPX4 rated, and so can be used or installed within a bathroom as long as the
appliance and its cables are not within Zones 0-2.
• If used within a bathroom, the circuit must be protected by a suitable RCD to prevent electric
shock.
• Do not allow the appliance to be submerged or sprayed with water.
• The unit must be installed in accordance with current regulations for the area of installation.
If unsure, professional advice should be sought.
• WARNING: To reduce the risk of fire or electrical shock, DO NOT use this appliance with any
solid-state speed control device or any variable speed controllers.
• Installation must be in accordance with all relevant local regulations applicable at the time
of installation.
• If electrical work is carried out within the bathroom which involves addition or alteration of
existing circuits, it may be notifiable to your local building control department (Part P). If
unsure, professional advice should be sought.
• Ensure that your heater is filled with glycol. If filling up your heater with Glycol, ensure to
leave room inside the unit for expansion. It is recommended to leave 10 percent of the unit
empty to allow for expansion of the liquid during operation.
• As the room temperature sensor is close to the radiator, it is unavoidable that heat from the
radiator will affect the room temperature reading during operation. This is normal for all
heaters with built in room temperature sensors.
• Illustrations in this manual may differ from the final product, this is due to constant product
development and improvement. There may also be slight variations between different
models covered by this manual.
PARTS SUPPLIED
HEATER
SCREWS (B) X8
WALL PLUGS X8
UPPER AND
LOWER
BRACKETS X4
PTFE TAPE X1
SPANNER X1
BRACKET COVER X4
(excluding
HC18-400-1.2WW,
HC26-400-1.2WW)
HEATING
ELEMENT
RUBBER WASHER X2
METAL WASHER X4
BRACKETS X4
(HC18-400-1.2WW,
HC26-400-1.2WW)
Bekijk gratis de handleiding van ElectriQ VS4-1600-1DGW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | VS4-1600-1DGW |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2837 MB |
