Handleiding
Je bekijkt pagina 5 van 30
5
• The appliance must be installed in a room without sources of ignition (e.g., open
flames, an operating gas appliance, or an operating electric heater).
• The unit must be installed on a solid vertical wall by a competent person. The
electricity supply must only be connected after installation is complete.
• R290 refrigerant gas complies with European environmental directives.
• R290 has a low GWP (Global Warming Potential) of 3.
• These air conditioners contains about 290 g of R290 refrigerant gas.
• Do not install or store in an unventilated space with an area smaller than 15m
2
per
unit. The room must be such as to prevent stagnation of possible leaks of
refrigerant gas as there could be a danger of fire or explosion hazard should the
refrigerant come into contact with electric heaters, stoves or other sources of
ignition.
• If the appliance is installed, used or stored in an unventilated room, the room must
be such as to prevent stagnation of possible leaks of refrigerant gas as there could
be a danger of fire or explosion should the refrigerant come into contact with
electric heaters, stoves or other sources of ignition.
• Refrigerant gas may be odourless.
• Do not use the product and contact the retailer for advice, if damage has occurred
to the unit which may have compromised the refrigerant system.
• In case of refrigerant leakage, immediately ventilate the area and contact qualified
service personnel.
• Any repairs or maintenance must only be carried out on the unit by a suitably
qualified engineer. Before opening and servicing the unit the authorized engineer
must be in possession of a copy of the manufacturer’s service manual and must
follow the safety information contained within it to ensure all hazards are
minimized.
• The refrigerant system should not be perforated or punctured.
• The PTC heater becomes hot during operation. Do not touch the heater element
to avoid burns.
• If the appliance makes unusual noises, odours, or smoke, immediately turn it off
and disconnect it from the power supply.
Energy Saving and Unit Safety Protection Tips
• Do not cover or restrict the airflow from the outlet or inlet grills. A minimum
distance of 50cm is advised.
• Keep the filters clean. Under normal conditions, filters should only need cleaning
once every three weeks (approximately). Since the filters remove airborne
particles, more frequent cleaning maybe necessary, depending on the air quality.
• For the initial start-up set the fan speed to maximum and the thermostat to 4-5
degrees lower than the current temperature. After, set the fan switch to low and
set the thermostat to your desired setting.
• To protect the unit, we recommend not using the cool mode when the ambient
temperature is higher than 35
o
C.
NOTE: Some pictures and information may vary from the final product. This is due
to continual product improvement.
Bekijk gratis de handleiding van ElectriQ IQOOL-SMART15HP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | IQOOL-SMART15HP |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2759 MB |
