Handleiding
Je bekijkt pagina 7 van 20
7
ATTACHING THE FEET
1. Rest the heater upside down on a soft cotton cloth or carpet.
2. Fix the feet to the base of the heater using the eight ST4*12 screws provided.
3. Line up the holes in the base with the holes in the feet, put the screws through the holes and
tighten with a screwdriver.
4. Screw on the castors.
NOTE
: This product must not be used on the floor without the feet being firmly attached.
WALL INSTALLATION
If you observe the safety distances, you can
install this heater in a bathroom. Please refer to
the diagram.
1. Press the hooks on the bracket to release
this from the back of the heater.
2. Using the bracket, mark on the wall the drill hole points. Use
a spirit level to ensure this is level.
3. Drill the four holes and insert the wall plugs.
4. Fix the bracket to the wall using four ST4*25 screws.
5. Position the heater so the holes on the back of it line up
to the screws. Then hang the heater onto the screws and
slot it into position.
Bekijk gratis de handleiding van ElectriQ ELPH750LEDWW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | ELPH750LEDWW |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 1533 MB |
