Handleiding
Je bekijkt pagina 10 van 25
Page 10 of 25
4. Change the minute value using the UP and DOWN buttons.
5. Hold the TIMER button for 3 seconds to confirm the minute value.
6. Change the day shown on the day indicator using the UP and DOWN buttons.
7. Leave the unit for 5 seconds, and the day and time will be saved.
TURNING ON AND OFF
The STANDBY button can be pressed to enter and exit standby mode. If the unit is not to
be used for a while, we would advise for it to be turned off using the switch on the side and
unplugged.
CHANGING THE DESIRED ROOM TEMPERATURE
The desired room temperature can be adjusted in both High heat and Low Heat modes,
using the UP and DOWN buttons. After the UP or DOWN button has been pressed, the
temperature display will show the desired temperature. The desired temperature can be
adjusted between 10°C and 49°C.
CHILD LOCK
Press and hold the UP and DOWN buttons for 3 seconds to activate and deactivate the
child lock. When the child lock is activated the Child lock symbol will be shown on the
display and the buttons are disabled on the control panel until the child lock is deactivated.
CHANGING THE POWER LEVEL
Repeatedly press the MODE button to change between the 3 available power modes:
High Heat
The heater will operate at High Power (2KW), the desired
temperature can be specified between 10°C and 49°C.
Low Heat
The heater will operate at Low Power (1KW), the desired
temperature can be specified between 10°C and 49°C.
Anti-Frost
The heater will operate to keep the room temperature between
5°C and 9°C in order to prevent freezing within the room. The
desired temperature cannot be changed.
OPEN WINDOW DETECTION
Hold MODE for 3 seconds to select Open Window Detection Mode. In this mode, when the
ambient temperature drops by 5°C within 10 minutes, the heater will register the possibility
of an open window in the room. If this happens, it will stop heating and enter standby
mode.
STANDBY TIMER
With the unit running with the desired settings, press the TIMER button. The countdown
timer symbol will illuminate and the unit will flash 00:00.
Repeatedly press the TIMER button to increase the duration of the timer (upto a maximum
of 24 hours).
Once the chosen timer length is selected, leave the unit, and after 10 seconds the timer will
start. After the chosen time period the heater will enter standby mode.
Bekijk gratis de handleiding van ElectriQ EGH20AWB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | EGH20AWB |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2074 MB |
