Handleiding
Je bekijkt pagina 11 van 25
Page 11 of 25
WEEKLY TIMER
Hold the PROGRAM button for 3 seconds to start the weekly timer. "Prog" will appear on
the display, signalling that the timer is active.
Press the TIMER button once, and the number “1" will begin to flash on the display to show
that the first day is selected. Use the UP and DOWN buttons to select the weekday to edit.
When you have selected the day to amend, press the TIMER button to confirm.
Each day has 6 time periods that can be programmed. Use the UP and DOWN buttons to
select the time period to adjust. Press the TIMER button to confirm the chosen time period.
The hours will begin to flash, and the symbol will be displayed. Adjust this using the UP
and DOWN buttons. Once the start hour is set, press the TIMER button and the minute value
will start to flash. Set this using the UP and DOWN buttons, before pressing the TIMER
button to confirm.
Once the start time has been set for the period of operation, the unit will then move onto
setting the finishing time. This will be indicated by the symbol on the display. This is set
in exactly the same way as the start time.
Once the TIMER button has been pressed to confirm the stop time the temperature display
will start to flash. Use the UP and DOWN buttons to confirm the desired temperature
during the period specified. The heater will only operate when the temperature is below
this value.
The above steps can then be repeated to set other time periods throughout the week.
The timer settings will be saved, and will not change as long as power is not disconnected
from the unit.
ADDITIONAL FEATURES
DISPLAY:
After any no operation for 30 seconds, the light on the display will become dim, but not
turn off. Press any button to return the screen to full brightness. Press and hold the DOWN
button for 3 seconds to turns off the display completely, leaving only the ON/OFF button
on, but dimmed, the unit will still function as normal. Press any button to turn the display
back on to its normal working state.
MEMORY FUNCTION:
In case of power failure or after turning the unit off, when turned back on the unit will start in
the previously used settings.
FACTORY RESET:
Press and hold the UP and DOWN buttons for 3 seconds to reset the unit back to its
factory settings. A beep will sound and the unit will start in COMFORT mode.
Bekijk gratis de handleiding van ElectriQ EGH20AW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ElectriQ |
| Model | EGH20AW |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 2074 MB |
