Eldom Toll WG100 handleiding
Handleiding
Je bekijkt pagina 13 van 40
13
• INTENDED USE
Fan WG100 is designed to improve thermal comfort in living spaces. With its help, the air is
set in motion, thus providing a pleasant cooling sensation.
• USE
− Before use, check that the unit is complete and undamaged.
− Before first use, unpack the appliance and assemble the individual components.
− Connect the tube (15) to the base (16) - fig. 1
− Slide out the tube (13) and lock it with the ring (14).
− Connect the body (9) to the tube (13) and lock by tightening the lock (14).
− Slide the rear mesh (6) onto the stem (7).
− Align the holes of the net (6) with the hooks on the motor housing (8) and fix with the nut
(5).
− Slide the propeller (4) onto the stem (7) and fix it with the nut (3).
− Loosen the bolt in the bracket (1), then put the bracket (1) on the mounted net (6).
− Fit the front net (2) into the bracket (1) and secure by tightening the screw in the bracket
(1) as far as it will go.
− Place assembled unit on a stable and level surface.
− Adjust height. Loosen the ring (14), slide the tube (13) in or out to the required height and
then lock by tightening the ring (14).
− Adjust the angle of the canopy.
− Unwind the cable completely.
• OPERATION
− All setting changes are confirmed with a beep.
− With the OFF button you can switch off all functions of the device at once.
− Connect the device to the mains according to the parameters given above.
− Switch on the appliance using the "SPEED/ON" button and by pressing it set the speed -
the indicator light (L, M, or H) will light up.
− Using the buttons on the control panel or remote control additionally select other
functions.
− To switch off press the "OFF" button.
• MODES OF OPERATION
NAT - natural mode
• Press the "SPEED/ON" button to switch on the fan.
• Press the "MODE" button until the "NAT" light comes on.
• The fan will cycle the speed from highest to lowest.
NOR - Normal mode
• Use the "SPEED/ON" button to switch on the fan and select the operating speed.
• Press the "MODE" button until the "NOR" light comes on.
• The fan will run at the selected speed.
Fig. 1
SLP - night mode
• Press the "SPEED/ON" button to switch on the fan and select the operating speed.
• Press the "MODE" button until the "SLP" light comes on.
• The fan will cycle on and off - operating at the selected speed.
• A
DDITIONAL FUNCTIONS
OSCILLATION - activation possible only from remote control
• Use the "SPEED/ON" button to switch on the fan and select the operating speed.
• Press the "SWING" button on the remote control.
• The fan will run at the selected speed.
• To deactivate the function, press the "SWING" button on the remote control.
TIMER
• This function allows you to set a time after which the unit will automatically switch
off.
• The function can only be activated when the unit is switched on.
• Use the "SPEED/ON" button to switch on the fan and select the operating speed.
• Press the "TIME" button on the remote control or ""TIME" on the control panel.
o 1 time - setting of automatic switch off in half an hour - the "0.5H" light will
come on,
o 2 times - setting automatic switch off in 1 hour - "1H" indicator light will come
on,
o 3 times - switch off in 1.5 hours - "1H" and "0.5H " indicator lights will come on,
o 4 times - switch off in 2 hours - "2H" indicator light will come on,
o 5 times - switch off in 2.5 hours - "2H" and "0.5H" indicator lights will come on,
o 6 times - switch off in 3 hours - "1H" and "2H" indicator lights will come on,
o 7 times - switch off in 3.5 hours - "1H" and "2H", "0.5H" indicator lights will come
on,
o 8 times - switch off in 4 hours - "4H" indicator light comes on,
o 9 times - switch off in 4.5 hours - "4H" and "0.5H" indicator lights will come on,
o 10 times - switch off in 5 hours - the "4H" and "1H" lights will come on,
o 11 times - switch off in 5.5 hours - the "4H", "1H" and "0.5H" lights will come on,
o 12 times - switch off in 6 hours - the "4H" and "2H" lights will come on,
o 13 times - switch off in 6.5 hours - the "4H", "2H" and "0.5H" lights will come on,
o 14 times - off in 7 hours - the "4H", "2H" and "1H" lights will come on,
o 15 times - switch off in 7.5 hours - the "4H", "2H", "1H" and "0.5H" lights will
come on.
• The fan will run at the selected speed.
• CLEANING AND MAINTENANCE
− Unplug the appliance from the mains and wait for the propeller to stop before cleaning.
− The appliance must not be submerged in water
− Wipe the unit with a damp cloth and then wipe dry.
− Remove the front net, propeller and rear net - wipe the components with a damp cloth
and then wipe dry.
− Do not use strong or surface-damaging cleaners to clean. Do not use any aggressive
cleaning agents.
• ENVIRONMENTAL PROTECTION
− The appliance is made of materials which can be recycled.
− It should be handed over to the applicable collection point for the recycling of electrical
and electronic equipment.
Bekijk gratis de handleiding van Eldom Toll WG100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eldom |
| Model | Toll WG100 |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 5068 MB |
