Elco VARION C-POWER handleiding
Handleiding
Je bekijkt pagina 8 van 44
8 | ELCO GmbH
Product information
Operation manual 50.0 | Status 10.2021
3. Product information
3.1 Functional principle
The combustion of gas in an industrial gas engine
powers a high-performance alternator that produces
electricity.
The heat that is generated by this process is used for
hot water provision and heating.
This principle is referred to as combined-heat-and-
power.
The control mechanism manages and monitors the
combustion process in the generation unit. The system
is operated via the operational display on the control
cabinet.
3.2 Registering with the energy provider
The energy provider must be informed about the
installation of the system. Obligations of the operator:
A Inform the energy provider about the system before
it is assembled.
A Fulfil the requirements specified by the energy
provider (e.g. registration, approval, compensation).
A Provide the energy provider with all the relevant
system data.
Technical data.
The electricity produced over and above the operator’s
own requirement can be fed into the energy provider’s
local electricity network in return for compensation. A
suitable application must be submitted to the energy
provider for this purpose.
3.3 Modes of operation
The system can be operated in five modes of operation
(including shutdown). The modes of operation are set
via the operational display.
“ELCO/Control” operating manual.
3.3.1 Ready for e-car charging button
Special mode for charging electric
vehicles. Pressing
the electric vehicle charging button starts the system
in a warm-up phase. Once this warm-up phase is
complete, the system runs under nominal load within
its pre-set parameters.
If the buffer charge exceeds a certain value, the
system switches over to modulation operation.
The electric vehicle charging button can be used by the
responsible chimney sweep to perform measurements
under nominal load.
3.3.2 Summer operation
In summer operation mode, the system only operates
at minimum capacity. The system only starts if the
storage battery has insufficient charge.
3.3.3 Heat-optimised
The system starts if a temperature requirement has
been set. If the storage battery has reached a specific
percentage charge, the system begins to power down
steplessly.
3.3.4 Electricity-optimised
The system starts to operate according to a temperature
requirement. Once a specific storage battery charge
has been reached, the system aligns itself to the
electricity consumption of the building.
3.3.5 Shutdown
The system is in hibernation mode. The system does
not start according to temperature requirements.
Bekijk gratis de handleiding van Elco VARION C-POWER, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elco |
| Model | VARION C-POWER |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5865 MB |
