Elation VOLT Q5 handleiding
Handleiding
Je bekijkt pagina 16 van 34
www.elationlighting.com
16 VOLT Q5™ User Manual ver 1
DMX-512 CONTROLLER CONNECTION
Connect the provided XLR cable to the female XLR output of your controller and the
other side to the male 3pin input of the VOLT Q5™. The diagram below illustrates a
typical DMX-512 connection when the fixture is in the 9 Channel Extended Mode.
You can chain multiple panels together through serial linking. The data link cable
included must be used. Always be sure daisy chain your in and out data
connections, never split or “Y” your DMX connections.
Address 1 Address 10 Address 19
DMX-512 CONNECTION WITH DMX TERMINATOR
A DMX terminator should be used in all DMX lines especially in longer runs. The use of
a terminator may avoid erratic behavior in your DMX line. A terminator is a 120 ohm
1/4 watt resistor that is connected between pins 2 and 3 of a male XLR connector
(DATA + and DATA -). This fixture is inserted in the female XLR connector of the last
fixture in your daisy chain to terminate the line. Using a line terminator will decrease
the possibilities of erratic behavior
.
Bekijk gratis de handleiding van Elation VOLT Q5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | VOLT Q5 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 5067 MB |
