Elation TVL1000 handleiding

Verlichting

Elation

10 pagina's

PDF beschikbaar

Handleiding

©Elation Professionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 7 ©Elation Professionals® - www.elationlighting.com - TVL1000 Instruction Manual Page 8

5-Pin XLR DMX Connectors.

Some manufactures use 5-pin XLR

connectors for DATA transmission in place of 3-pin. 5-pin XLR xtures

may be implemented in a 3-pin XLR DMX line. When inserting stan-

dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be

used, these adaptors are readily available at most electric stores. The

chart below details a proper cable conversion.

Conductor 5-Pin XLR Male (In)3-Pin XLR Female (Out)

Pin 1

Pin 5 - Do Not Use

Pin 4 - Do Not Use

Pin 3

Pin 2

Pin 1

Pin 3

Pin 2

Not Used

Data True (+ signal)

Data Compliment (- signal)

Ground/Shield

3-Pin XLR to 5-Pin XLR Conversion

TVL1000 Set Up TVL1000 Control Panel

1 Display: To show the various menus and the selected functions

2 Indicator LED: First make sure to turn on the battery switch.

DMX On DMX input present

MASTER

On Master Mode

SLAVE On Slave Mode

BATTERY On Battery is full

3 Button:

MENU To select the programming functions

DOWN

To go backward in the selected functions

UP To go forward in the selected functions

ENTER To confirm the selected functions

Note: Connect the fixture to a main power supply. If the battery indicator

blinks slowly, it means the battery is being charged. When the indicator

stops blinking and stays lit, it means the battery is at full charge.

When using the battery power, the indicator light will not bet lit. If the

remaining battery power is less then 16%, the indicator will blink fast

reminding you that the battery is low and that it needs to be charged.

4 Dimmer adjust knob: Adjust lightness for the unit from 0~100.

5 Color temperature adjustment: Adjust the color temperature from 3200k to 6500k,

25K as a step.

6 DMX output: For DMX512 link, use 3/5-pin XLR plug cable to link the next unit.

7 DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal

8 Main input: Connect to main power supply.

9 Main output: Connect to the main power ofthe next unit.

⑩ Battery switch: Turn on or turn off the switch for battery mode. This switch can only

control battery.

The TVL1000 is fully operational in three different mounting positions,

hanging upside-down from a ceiling, hanging sideways on truss-

ing, or set on a at level surface. The unit should be mounted using

a mounting clamp (not provided), afxing it to the mounting bracket

that is provided with the unit. Always ensure that the unit is rmly

xed to avoid vibration and slipping while operating. Always ensure

that the structure to which you are attaching the unit is secure and is

able to support a weight of 10 times the unit’s weight. Also, always

use a safety cable that can hold 12 times the weight of the unit when

installing the xture.

The equipment must be installed by a professional, and it must be

installed in a place where it is out of the reach of people’s grasp.

TVL1000 Installation

Bekijk gratis de handleiding van Elation TVL1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.