Elation Show Designer 2 handleiding
Handleiding
Je bekijkt pagina 10 van 38
!
10!
MENU AND SETUP FUNCTIONS
MODIFY FIXTURE
This allows you modify some of the channel attributes of a fixture. You can also use this to
create a new fixture that isn’t in the library by modifying an existing one. To do this you must
first select a fixture as described above in the “Choose Fixture” section. When trying to create a
new fixture choose something that is similar to the one you are trying to create or start with
the “Generic Dimmer” which is the first choice from the list. You can later use the “Copy
Fixture” feature as described in the next section to duplicate the new fixture.
There are nine fixture attributes that can be modified. The attributes are: fixture name, number
of channels, black channel, black value, pan channel, pan fine channel, tilt channel, tilt fine
channel and crossfade mode. From the “Modify Fixture” menu, use data wheel #1 to select the
fixture you want to modify. Next use data wheel #2 to select from the nine fixture attributes.
Next use data wheel #3 to select the value for the attribute you are changing. Finally, you must
always press “enter” to record the changes you make to each attribute. The message “DONE”
will appear in the display when the change has been recorded. The fixture attributes are
described in the following paragraphs.
NAME is the fixture name that appears whenever you select or deselect a fixture. You may
want to modify this attribute for all of your fixtures to show fixture purpose or location. You must
place the underline cursor on the character you want to edit, or you can use the external
keyboard to enter a fixture name.
CHANNELS is the total number of channels used by the fixture. This can be any number from
1 to 32. When you change the number of channels, be aware that other things such as fixture
addresses and number of multi fixtures can be automatically changed when you do this. Fixture
attributes such as black channel, pan or tilt will also be automatically disabled if you select a
number that is smaller than the channel numbers that are already assigned to those attributes.
For example, if you already assigned pan to channel 8 and you reduce the total number of
channels for the fixture to 4, pan will automatically be set to “none”. Likewise, if you increase
the number of channels from 8 to 9 and you had previously set up 4 multi fixtures using all 32
channels, the multi fixture setting will automatically be reset back to 1.
BLACK CHANNEL is the channel that will be affected when the “black” switch is pressed. You
can choose any available fixture channel as well as “ALL” which will force all channels to the
selected black value.
BLACK VALUE is the DMX value that will be sent to the selected black channel(s). This will
accommodate fixtures that use the gobo wheel for blackout and use a value other than 0 to set
the gobo wheel to black. You may also want to blackout all channels to a value other than 0
since this is used as a reset by some fixtures. For some fixtures a value of 1 achieves the same
result as a value of 0 for blackout.
PAN CHANNEL is the channel used by the fixture for pan. This can also be set to “none” if the
fixture does not have a pan feature. This is also the pan coarse channel or pan high byte
channel for those fixtures that use two channels to control pan. This directs the joystick output
as well as other pan functions such as factory chases.
Bekijk gratis de handleiding van Elation Show Designer 2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | Show Designer 2 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 3837 MB |
