Elation Power Spot 250 handleiding
Handleiding
Je bekijkt pagina 37 van 48
Power Spot 250™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 37
8. Changing/Replacing Gobos
The POWER SPOT 250™ is fitted with a standard size gobo wheel that accepts gobos with
an outside diameter of 27mm and a viewable image size of 23mm. Glass or steel gobos
may be used. Please follow the safety procedures and installation below for proper and
pain gobo exchange
Safety Regulations
• Pull out the main plug!
• If the unit was recently in operation, be sure to allow a minimum of 20 minutes to
cool before opening the unit.
• To avoid eye injury and reduce exposure to UV radiation always be sure to replace
the protective outside casing before attempting operation.
8.1 Installing/Replacing Gobos
8.1.1 Always be sure to disconnect the main power supply before attempting any
service.
8.1.2 Remove the upper shell of the protective cover by removing the 4 retaining
Phillips screws, 2 located on the front and 2 located on the rear of the head.
8.1.3 Once the outer cover has been removed, rotate the gobo wheel to a position that
allows easy access to the gobo you want to replace. Using a small flat-head
screwdriver, gently pry out the gobo retaining spring.
8.1.4 Replace the gobo and reinsert the retaining spring to secure the new gobo in
place. Be sure the retaining spring is insert properly to avoid damage to the
wheel.
8.1.5 Reassemble the POWER SPOT 250™ in reverse order.
Bekijk gratis de handleiding van Elation Power Spot 250, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | Power Spot 250 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4681 MB |
