Elation PARAGON LT handleiding
Handleiding
Je bekijkt pagina 3 van 7
3
RGB MODULE INSTALLATION INSTRUCTIONS
To install the optional RGB Module accessory onto the Elation Paragon LT, follow the
procedure shown below.
Tools Required: 3mm Hex Driver; #2 Phillips Screwdriver
Step 1: Use the pan and tilt locks to x the head in a vertical orientation, with the pan lock facing
towards you. Remove the 13 head cover fasteners, then remove the head covers.
Step 2: Locate the Gobo/RGB/CMY module assembly. Disconnect the two electrical connectors
near the bottom left of the head (bottom middle image). Next, locate the two mounting tabs for
the Gobo/RGB/CMY module. Loosen, but do not completely remove, the two fasteners holding
each tab in place (top middle image). This will allow the tabs to slip slightly downwards, releasing
the module chassis. The module can now be pulled free from the head of the xture.
LT
Pan Lock
Tilt Lock
Bekijk gratis de handleiding van Elation PARAGON LT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | PARAGON LT |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4436 MB |
