Elation OPTI QUAD PAR handleiding

Verlichting

Elation

10 pagina's

PDF beschikbaar

Handleiding

LED Display On/Off:

To set the LED display to turn off after 10 seconds, press the MODE

button until DispPerm ON is displayed, press the UP button to dis-

play DispPerm Off. Now the display will disappear after 10s. Press

any button for at least 3secs. to turn the display on again. Be advised

though that the display will turn off automatically after 10 seconds.

DispPerm ON = LCD display on at all times.

DispPerm Off = LCD display shuts off after 10 seconds.

Operating Modes:

You can use the Opti Quad Par in five ways:

• Sound-Active mode - The unit will react to sound, chasing through the

built in programs.

• Macro Mode - There are 32 color macros to choose from.

• Auto Mode - There are 9 built in programs to choose from.

• RGB mode - Control the intensity of all three colors adjusting the

intensity to your desire.

• DMX control mode - This function will allow you to control each

individual fixtures traits with a standard DMX 512 controller such as

as the Elation® Show Designer™.

Master-Slave Operation:

This function will allows you to link units together to run in a Master-

Slave mode. In Master-Slave operation one unit will act as the controlling

unit and the others will react to the controlling units built-in programs.

Any unit can act as a Master or as a Slave however, only one unit can be

programmed to act as the “Master.”

Master-Slave Connections and Settings:

1. Daisy chain your units via the XLR connector on the rear of the unit.

Use standard XLR microphone cables to link your units together.

Remember that the Male XLR connector is the input and the Female

XLR connector is the ouput. The first unit in the chain (master) will

use the female XLR connector only. The last unit in the chain will use

the male XLR connector only.

2. Set the “Master” unit to your desired mode or operation.

3. For the “Slave” unit(s), set the display to DMX mode 3, or 3 Channel

mode. The display should read “3000” or any variables, i.e “3001”,

“3002 etc..

4. Connect the “Slave” unit or units and they will automatically start to

Opti Quad Par Operating Instructions

Elation Professional - www.elationlighting.com - Opti Quad Par Instruction Manual Page 7 Elation Professional - www.elationlighting.com - Opti Quad Par Instruction Manual Page 8

5-Pin XLR DMX Connectors.

Some manufactures use 5-pin DMX-

512 data cables for DATA transmission in place of 3-pin. 5-pin DMX

xtures may be implemented in a 3-pin DMX line. When inserting stan-

dard 5-pin data cables in to a 3-pin line a cable adaptor must be used,

these adaptors are readily available at most electric stores. The chart

below details a proper cable conversion.

Opti Quad Par DMX Set Up

Conductor 5-Pin XLR Male (In)3-Pin XLR Female (Out)

Pin 1

Pin 5 - Do Not Use

Pin 4 - Do Not Use

Pin 3

Pin 2

Pin 1

Pin 3

Pin 2

Not Used

Data True (+ signal)

Data Compliment (- signal)

Ground/Shield

3-Pin XLR to 5-Pin XLR Conversion

Bekijk gratis de handleiding van Elation OPTI QUAD PAR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.