Elation EWDMX IP handleiding
Handleiding
Je bekijkt pagina 14 van 18
www.elationlighting.com
14 EWDMX IP™ User Manual ver 1
G3/G4 MODES, & RDM OPERATION
EWDMX IP
™
can change between Generation 3 protocol (compatibility for older
units), and the new Generation 4 protocol, which supports Invisiwire, Datasafe and
RDM (Remote Device Management). G4 receivers automatically detect the mode
the transmitter is in, so you only need to change the mode of the transmitter to
change the mode of the entire system. When the protocol mode has been
changed, receivers need to be re-connected to their respective transmitters.
TO CHANGE MODES
1. Hold
down the RED FUNCTION button for over 10 seconds. Initially, you will see the
LINK light blink slowly. Do not release the RED FUNCTION button at this point, as this
will disconnect all RECEIVERS. Wait until you see ALL of the LEDs light up, then the
RED CTL light illuminate, before releasing the RED FUNCTION button.
2. Press and release the RED FUNCTION button to change between the (3) modes.
Note that each time the RED FUNCTION is pressed, the unit will toggle between all
the different modes.
3. Once the desired mode is set, power cycle the unit to begin use in that mode.
The Following Modes Can Be Set:
G4 2.4GHz (First green SIGNAL indicator on the left and G4 Light is static on).
G4 RDM (First green SIGNAL indicator on the left is off but G4 Light is static on).
G3 2.4GHz (First green SIGNAL indicator on the left is static on but G4 Light is off).
Note: Units ship standard as G3, 2.4GHz for backward compatibility reasons
Bekijk gratis de handleiding van Elation EWDMX IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | EWDMX IP |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 1932 MB |
