Elation ELAR Tri Brick handleiding
Handleiding
Je bekijkt pagina 19 van 44
ELAR Tri Brick™
©Elation Professional, Los Angeles Ca. 18 www.ElationLighting.com
(15 + 16), and so on.
Note: During start-up the ELAR TRI BRICK™ will automatically detect whether a DMX data
signal is being received or not. If a DMX data signal is being received, the display will show
"A.XXX" (XXX representing the actual DMX address). If the fixture is not receiving a DMX
signal the display will flash "A.XXX" (XXX representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3-pin or 5-pin XLR plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
- The DMX controller is switched off or defective.
- The DMX cable from the controller merging with included IP Rated Cable adapter is
not connected securely
- The DMX cable or connector is defective.
- A DMX terminator has must be inserted into the last fixture in your DMX chain.
Bekijk gratis de handleiding van Elation ELAR Tri Brick, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | ELAR Tri Brick |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4742 MB |
