Elation Design LED 36UV handleiding
Handleiding
Je bekijkt pagina 11 van 32
DESIGN LED 36UV™
©Elation Professional, Los Angeles Ca. 10 www.ElationLighting.com
hung, mounted, or stood straight up.
4. Diffusion Lens – This lens is used to both protect the LEDs as well a diffuse the light
output.
5. LED Assembly – 36 1-watt LEDs construct the LED assembly.
6. Power Cord – Provides main power to the unit.
7. On/Off Power Switch – Controls main power to the unit.
8. DMX In Jack – This jack accepts an incoming DMX signal via a male, 3-pin XLR jack.
9. DMX Out Jack – This jack is used to send an incoming DMX signal to the next fixture in
the DMX chain via a female, 3-pin XLR jack.
10. Fuse Holder Housing – This housing holds the GMA (2) amp protective fuse. Never
use a fuse greater than that specified by the manufacture. Using a fuse other than that
specified could seriously damage the unit and will void your manufactures warranty.
11. Dipswitch Assembly – These dipswitches are used to set the DMX address,
master–slave settings, and other special functions. See the dipswitch chart on page 16 for
more information on the dipswitch functions.
Bekijk gratis de handleiding van Elation Design LED 36UV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | Design LED 36UV |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 3673 MB |
