Elation DESIGN LED 108IP handleiding
Handleiding
Je bekijkt pagina 18 van 36
DESIGN LED 108IP™
©Elation Professional, Los Angeles Ca. 17 www.ElationLighting.com
be set to three or four channels), you should set the starting DMX address of the first unit to
1, the second unit to 4 (3 + 1), the third unit to 7 (3 + 4), and so on.
Note: During start-up the Design LED 108IP™ will automatically detect whether a DMX data
signal is being received or not. If a DMX data signal is being received, the display will show
"A.XXX" (XXX representing the actual DMX address). If the fixture is not receiving a DMX
signal the display will flash "A.XXX" (XXX representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3-pin or 5-pin XLR plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
- The DMX controller is switched off or defective.
- The DMX cable or connector is defective.
- A DMX terminator has been inserted into the last fixture in your DMX chain.
Bekijk gratis de handleiding van Elation DESIGN LED 108IP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elation |
| Model | DESIGN LED 108IP |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4289 MB |
