Ekko ES100E handleiding
Handleiding
Je bekijkt pagina 15 van 65
Work Area Safety
13
Explosion Hazard
Keep sparks, flames and
lighted tobacco away
from batteries. Batteries
emit explosive gas.
The battery tray should
remain open during the
entire charging cycle.
Do not contact the
battery terminals or the
cable clamps with tools
that may cause sparks.
Component Damage Hazard
Do not use any battery charger greater than
24V to charge the batteries.
When the battery power is insufficient or
excessive discharge, do not operate the
machine.
Electrocution/Burn Hazards
Connect the battery charger to a grounded,
AC 3-wire electrical outlet only.
Inspect daily for damaged cords, cables and
wires. Replace damaged items before
operating.
Avoid electrical shock from contact with
battery terminals. Remove all rings, watches
and other jewelry.
Tip-over Hazards
Batteries are used as counterweight and are
critical to machine stability. Do not use
batteries that weigh less than the original
equipment. Each battery must weigh 61.5lbs
（ ES120 battery is 80 lbs） , Battery tray
including batteries must weigh a minimum of
the following requirements:
Model
Weight of tray
ES40E
170 lbs
ES60
340 lbs
ES80
ES100
400 lbs
ES120
465 lbs
Lift Hazard
Use the appropriate number of people and
proper lifting techniques when lifting batteries.
Lockout after each use
1. Select a safe parking location—firm level
surface, clear of obstruction and traffic.
2. Lower the platform.
3. Turn the key switch to the off position and
remove the key to secure from
unauthorized use.
4. Chock the wheels.
5. Charge the batteries.
Bekijk gratis de handleiding van Ekko ES100E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ekko |
| Model | ES100E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8709 MB |
