Ekko EK07S handleiding
Handleiding
Je bekijkt pagina 13 van 22
- 12 -
Will weight low, lean back door frame, to storage goods moving close to the pile
of deceleration, when determining forklift with pile goods into a linear state,
stepping on the brakes slowly adjust the door frame Angle to the vertical state,
increase the weight will be slightly more than goods pile height, and then slowly
driving forklift driving forward to pile top stop. Heap controls control lever
slowly, once handling stacked drags the weight, the goods fork to the hollow
position, from the weight of the goods fork, make sure barrier-free backward
position, can retreat. After goods fork out weight reduce goods fork, door frame
round of the reentry after handling operation.
3.5 Safe Operation Rules
3.5.1 Requirements for drivers: The forklift must be operated by a trained staff.
He can demonstrate the operation of the goods to the users, and can clearly guide
the user how to operate the forklift.
3.5.2 Drivers’ rights, obligations and responsibilities: Has been trained by the
operation of the vehicle, the driver must be clear of his rights and obligations;
and he is familiar with the contents of the relevant operating instructions. If the
vehicle is pedestrian, the driver must also wear safety boots.
3.5.3 Prohibit unauthorized personnel to operate: the driver is responsible for
the vehicle at work. He must prevent unauthorized persons from driving or
operating this vehicle. It is forbidden to use the vehicle to transport or lift
personnel.
3.5.4 Malfunctions and defects: There is any malfunction or defect for the
vehicle, must immediately inform management. If the vehicle cannot be safely
operated (e.g.: wheel wear or brake failure), then it must stop using until it is
fully repaired.
3.5.5 Safe operation and environmental protection: inspection and
maintenance must be performed in accordance with the time intervals on the
maintenance list.
Parts of the vehicle cannot be changed without any permission, especially
safety devices. The operating speed of the vehicle is not allowed to change.
All original spare parts have been verified by quality assurance department.
To ensure the safety and reliability of the operation of the vehicle must use only
the manufacturer's spare parts. The old parts, such as oils and fuels must be
handled in accordance with the relevant environmental protection rules.
3.5.6 Hazardous area: Hazardous area usually refers to the following range:
vehicle or its load lifting devices (e.g. fork or accessories) is dangerous for
personnel when running or lifting movements, or the ongoing regional transport
loads. Typically, this range extends to the load or vehicle accessories landing
area.
Unauthorized personnel must be asked to leave the dangerous zone. As long as
the situation might cause some kind of damage, the driver must give a warning,
if the driver asked the person to leave but did not leave the danger zone, the
driver must immediately stop the vehicle
Bekijk gratis de handleiding van Ekko EK07S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ekko |
| Model | EK07S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2446 MB |
