Ekko EB16EA handleiding
Handleiding
Je bekijkt pagina 21 van 28
22
Figure13：Battery discharge display
cover ,Remove the battery connector .Then lift the battery from the top of the frame
directly .Caution: If the lifting equipment is not safe. The battery may tip
over .Installation is the opposite procedure of remove ,Please connect the positive
terminal firstly .Otherwise the car is easy to damage
9.2Battery display
As shown in Figure 13,The discharge condition is indicated by 10 red LED display
segments. The rightmost LED will only illuminate when the battery is properly charged.
As the state of charge of the battery drops, the LED lights illuminate in sequence, but only
one light at a time.
⚫ The second LED on the left flashes, indicating “energy reserve” (70% discharge
depth)
⚫ The leftmost 2 LED flash alternately, indicating “power is empty” (80% of the depth
of discharge)
9.3Charging
⚫ Only be charged with included charger
⚫ Before using the charger ,please fully understand the contents of the
charger manual
⚫ Ensure good ventilation in charging room
⚫ Fully Charged situation can only be viewed from the display.to check this
situation ,you need to interrupt the charging and start the car.
Park the car in a safe area that provide dedicated power .Lower fork and remove
the cargo. Turnoff the power of car, Open the battery cover, then connect the
connector and Charger. The charger starts charging .Finishing charging .Remove
Battery discharge
Battery fully charged
！
Bekijk gratis de handleiding van Ekko EB16EA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ekko |
| Model | EB16EA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4750 MB |
