Eibenstock USD 182 handleiding
Handleiding
Je bekijkt pagina 16 van 32
15
Care and maintenance
Always keep the drill rig clean, especially the column with the toothing
and the 4 sliding rolls in the machine holder. In order to allow the free
movement of the pinion shaft, it should be slightly lubricated.
In order to achieve a good performance of the drill rig, the 4 sliding rolls
in the machine holder have to move along the column without slackness.
Attention!
After every tenth drilling you should check if the sliding pieces
have got loose
-
fitting due to drilling vibration.
Slide 10:
If the position of the castors is altered with the result that the machine holder is
given too much slack or clearance, this can be readjusted by doing the following:
Loosen the wing nut (B) on the castor marked E with the aid of a open-ended
wrench SW 19.
The pressure exerted by the castor can be adjusted by lightly turning the wing
nut (A) with the aid of an open-end wrench SW 19.
Once the adjustment of the castor has been successfully performed, the wing
nut (B) must be re-tightened.
Slide 5:
B
A
Loosen the counter nut on the Allen screw by
means of an jaw wrench SW17
Adjust the Allen screws and the position of the
thrust piece to the column by means of a hex
head wrench.
Tighten the counter nut again and check whether
the carriage moves easily on the column.
Bekijk gratis de handleiding van Eibenstock USD 182, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | USD 182 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6014 MB |
