Eibenstock PLE 182 handleiding
Handleiding
Je bekijkt pagina 26 van 144
25
Wet drilling
Open the ball valve and switch the tool on. Hold the tool tight with both hands.
Locate the tool slightly inclined. Once the drill bit is in the material (approx.
1/8 to 1/4 of the circumference), bring the tool into an angle of 90 degrees
and continue drilling.
Take care that the drill bit is not out of line.
Advance the tool according to bit diameter and machine power. Observe the
LED in the handle. If it lights red, reduce your pressing force.
In case the bit gets jammed, to not dry to release it by switching the tool
on and off. This would cause premature wearing of the safety clutch. Switch
the tool off immediately and unfix the drill bit by turning to the left or right
using an appropriate open-end wrench. Cautiously pull the tool out of the
borehole.
Use of a water suction ring is mandatory for “overhead drilling”.
Drill Bits
Diamond drill bits with a 1 ¼" UNC female thread and R ½" male thread can
be screwed directly onto the working spindle.
Use only appropriate drill bits for the material to be drilled in. You can protect
your tool by using only well balanced drill bits without deformation.
Make sure that the diamond segments have sufficient cutting clearance
towards the bit body.
Changing Drill Bits
Attention!
When you use or sharpen the machine, it might heat up enormously.
You could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the drill bit.
The drilling spindle has a right-hand thread. To ease screwing on and off,
always use a SW 32 open-end wrench at the drilling spindle. Never use a
hammer, because this may damage both the drill bit and the tool.
Some water-resistant grease on the drilling spindle threat or a copper ring
between spindle and drill bit will simplify removal of the drill bit.
Bekijk gratis de handleiding van Eibenstock PLE 182, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | PLE 182 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19223 MB |
