Eibenstock EPG 400 Set I handleiding
Handleiding
Je bekijkt pagina 15 van 105
15
Make sure that the persons standing in the work area are not hit by
particles which fly around.
Keep the handles dry, clean and free of oil and grease.
During operation always hold the machine with both hands.
Caution! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Electrical Connection
Before commissioning, check that the mains voltage and
mains frequency match the specifications on the rating
plate.Voltage deviations of + 6 % and - 10 % are
permissible.The EPG 400 plastering machine is designed in
protection class II.
Only use extension cables with a sufficient cross-section. If the cross-section
is too small, this can lead to excessive power losses and overheating of the
machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
Cross section in
sq. mm
1.5
2.5
110V
20 m
40 m
230V 50 m 80 m
Switching on and off
Short-Time Operation
Switching-on: press on/off switch
Switching-off: release on/off switch
Permanent Operation (only for working with telescopic rod)
Switching-on: press the on/off switch and, keeping it pressed, engage
the lock button
Switching-off: press the on/off switch and let it go off again
!
Attention!
After every machine-related standstill or power failure, the
locking button must be unlocked immediately by pressing
the on/off switch to prevent the machine from restarting
unintentionally (risk of injury).
Bekijk gratis de handleiding van Eibenstock EPG 400 Set I, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | EPG 400 Set I |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10433 MB |
