Eibenstock EPF 200/3 handleiding
Handleiding
Je bekijkt pagina 16 van 52
16
During use, the operator and other persons standing nearby have
to wear suitable ear protectors, a dust mask and protection
goggles.
Make sure that persons in the work space are not endangered by
Particles flying around.
Always hold the machine with both hands.
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions please refer to the enclosure!
First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate. Voltage differences from + 6 %
to – 10 % are allowed. The tool includes a start-up speed limiter to prevent
fast expulsion fuses from unindented responding. Only use extension
cables with a sufficient cross-section. A cross-section which is too small
could cause a considerable drop in performance and an overheating of
machine and cable. The tool includes a start-up speed limiter to prevent fast
expulsion fuses from unintended responding.
Switching on and off
Note:
For safety reasons, the on/off switch cannot be locked; it must remain
pressed during the entire operation. To switch off the power tool, release
the on/off switch.
Height Adjustment
The EPF 200-3 includes a height adjustable protective hood.
Depending on the degree to which the milling disk is worn, the milling depth
can be adjusted to a max. depth of 5 mm.
Electrical Connection
To start the power tool, first press the lock-off
button(1), then press the on/off switch (2) and
keep it pressed.
1
2
Bekijk gratis de handleiding van Eibenstock EPF 200/3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | EPF 200/3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9073 MB |
