Eibenstock EPF 1503 handleiding
Handleiding
Je bekijkt pagina 17 van 80
17
ļ§ Do not work on surfaces with steel reinforcements which lie open.
For further safety instructions please refer to the enclosure!
First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate. Voltage differences from + 6 %
to ā 10 % are allowed.
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Switching on and off
Short-time operation
ON: Press the ON/OFF switch.
OFF: Release the ON/OFF switch.
Long-time operation (only for workings with Floor Guiding System)
ON: Keeping the ON/OFF switch pressed, push in the arrestor button.
OFF: Press and release the ON/OFF switch again.
!
Attention!
In case of every stop of the machine or a power cut, the
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
Retooling
Attention!
Pull out the mains plug before retooling.
The cutting stars may be hot.
Wear protective gloves!
Remove the three wing screws from the height adjustment (refer to
following section). Remove the brush rim and the height adjustment.
Open the Allen screw M8 using the supplied size 6 Allen key. Attention!
The screws have a left-hand thread.
Holding the bush for the capstan with the stars and the thrust
washers . Put the new stars on. Fix the component parts referring to the
drawing.
Attention! Use only Allen screws with locking fastener.
Electrical Connection
1
4
3
5
2
Bekijk gratis de handleiding van Eibenstock EPF 1503, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | EPF 1503 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15804 MB |
