Eibenstock EHR 15.2 SB handleiding
Handleiding
Je bekijkt pagina 14 van 84
13
During use, always hold the machine with both hands and maintain a
safe standing position. Start up and run down the machine in the mixing
container only. Pay attention to the reaction moment of the machine.
For further safety instructions, please refer to the enclosure.
Electrical Connection
Before starting the machine check the correspondence between voltage and
frequency against the data mentioned on the identification plate. Voltage
differences from + 6 % and – 10 % are allowed. The mixing machine is made
in protection class II. Only use extension cables with a sufficient cross-
section. A cross-section which is too small could lead to an excessive power
loss and to overheating of motor and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
Cross section in sq. mm
1.5
2.5
110V
20 m
40 m
230V
50 m
80 m
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread. Keep threads
and front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Tool Protection
A wrong handling can result in damages.
Hence, the following instructions should be observed:
Use only paddles recommended from the producer with M 14 – internal
thread (diameter max. 120 mm).
Do not allow blocking of the tool due to overload.
Use only original parts from EIBENSTOCK.
Bekijk gratis de handleiding van Eibenstock EHR 15.2 SB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | EHR 15.2 SB |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7878 MB |
