Eibenstock DBE 352 handleiding
Handleiding
Je bekijkt pagina 26 van 234
26
Screw an adequate extension between drill bit and motor. If the collet of the
drill bit is 1¼”, please do not forget the copper rings which make the removal
of the drill bit easier.
Overload Protection
In order to protect the operator, motor and drill bit, the EBM 352/3 is equipped
with a mechanical, electronic and thermal overload protection.
Mechanical: If the drill bit is suddenly blocked in the hole, a clutch will
slip disengaging the drill spindle from the motor.
Electronic: To warn the user against overstressing the tool by applying
to high feed force, a LED is mounted on the motor cap. It
does not light during no-load run or at normal load. In case
of over- load, the LED lights red. Now the tool must be
discharged. In case of longer non-observation of the red
indication, the electronics will independently cut the unit off.
After discharge and switching the tool off and on again, you
can continue working.
Thermal: In case of permanent overload, a thermocouple protects the
motor against destruction. Here also, the user is warned by
the overload indicator. Shortly before the maximum
temperature is reached, the indicator flashes red.
In that case, the tool switches off and can only be restarted
after a certain cooling-down period (approx. 2 minutes). The
overload indicator flashes until the machine has cooled
sufficiently and can be used again. The cooling-down time
depends on the temperature of the motor winding and
ambient temperature.
Safety Clutch
The safety clutch should absorb shock and excessive stress. It is an aid
and not an absolute protection. Therefore, you have to handle and drill
carefully. To keep it in good condition, the clutch should slip for a very
short time (max. 2 seconds) in each case only. Slipping for longer
periods destroys the safety clutch. After excessive wearing the clutch
has to be renewed by an authorized service shop.
Fracture of Segments
If a diamond segment, parts of the reinforcement or something similar
breaks out, and consequently the drill bit seizes, stop working on this bore
and drill a hole with the same centre and a diameter being 15 – 20 mm
bigger.
Do not try to finish your work using another drill bit of the same
diameter!
Bekijk gratis de handleiding van Eibenstock DBE 352, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | DBE 352 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 41871 MB |
