Eibenstock DBE 162 handleiding
Handleiding
Je bekijkt pagina 22 van 172
21
!
Attention!
The PRCD protective switch must not lay in water.
PRCD protective switches must not be used to switch the tool on
and off.
Before starting your work, check the proper function by
pressing the TEST button.
Prior to putting the tool into operation, check the mains voltage for
conformity with the requirements of the tool’s nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
Use only extension cable with sufficient cross-section (min. 2,5 mm
2
). A
cross-section which is to small could lead to excessive power loss and to
overheating the motor and the cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage Cross section in sq. mm
1.5 2.5
110V 20 m 40 m
230V 50 m 80 m
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Additional Handle
Switching ON and OFF
Short-time operation
ON: Press the ON/OFF switch
OFF: Release the ON/OFF switch
Long-time operation
ON: Keeping the ON/Off switch pressed, push in the arrestor button.
OFF: Press and release the ON/OFF switch again.
For manual drilling, the ETN 162/3 may be used only together
with its additional handle which comes with the tools.
Place it on the gearing collar from the front and fix it by
turning the handle in direction of the arrow.
Bekijk gratis de handleiding van Eibenstock DBE 162, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Eibenstock |
| Model | DBE 162 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 22603 MB |
