Ecoteck Unica handleiding
Handleiding
Je bekijkt pagina 23 van 40
Use and maintenance manual - Model: “UNICA 10 V/C”
23
ENGLISH
11.3
PELLET/ASPIRATION RATIO
The PELLET-ASPIRATION ratio setting
allows you to change, with immediate effect, the
quantity of pellets loaded in the brazier and the
quantity of air inbound of the product, tested and
inspected with DIN PLUS certied pellets. If you use
other pellets or uncertied pellets, combustion may
need to be adjusted. Normally, the change is exe-
cuted on the ASPIRATION percentage to improve
combustion; if oxygen adjustment is not efcient, you
may need to also change the percentage of PELLETS
falling.
OPERATING PROCEDURE:
MENU >> USER SETTINGS >> P/A RATIO
Access the menu by pressing key
Scroll the items to SET USER, key
Access the menu by pressing key
Scroll the items to P/A RATIO with the key
Access the function by pressing key
OK
OK
OK
OK
Edit the pellet setting with the keys
The values vary from -5: reduction in pellet load in %
to +5: increase in pellet load in %
Conrm by pressing the key and pass
to edit extraction.
OK
Edit the extraction setting, keys
The values vary from -5: reduction in aspiration in %
to +5: increase in aspiration in %
Conrm by pressing the key and exit adjustment
to return to the USER SETTINGS screen.
As for example outlined above, a percentage of -2
PELLET and +3 EXTRACTION was set;
this kind of setting results from the fact combustion
is lacking oxygen and the pellets are small in size
compared to the average 2cm.
OK
Select the type of screen you want to
display, with the keys
Access the relevant screen with the key
During editing, remember that:
• to return to the previous data, without saving
the last data changed, press the key
• if you intend changing a single datum, having ter
minated the change, press the key multiple times
until you exit the function described in the
paragraph.
To return to the STAND-BY screen, use the
key , repeating the operation multiple times.
OK
The number indicated, for setting change, refers
to a percentage change which acts on the de-
fault parameters set on the electronic board, this
only affects the work phase. These values should
be changed in the event of poor combustion, due
in many cases to use of pellets different from those
used for testing the appliance.
11.4
STOVE STATUS
This function allows you to check the most important
parameters are working properly on the appliance.
Two screens are outlined below which show the list
of real data of the product, useful for the support
service during the control phases.
OPERATING PROCEDURE:
MENU >> USER SETTINGS >> STOVE STATUS
Access the menu by pressing key
Scroll the items to USER SETTINGS with the key
Access the menu by pressing key
Scroll the items to STOVE STATUS with the key
Access the function by pressing key
OK
OK
OK
OK
OK
Bekijk gratis de handleiding van Ecoteck Unica, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecoteck |
| Model | Unica |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8886 MB |
