Ecler VEO-XWT44E handleiding
Handleiding
Je bekijkt pagina 11 van 23
11
RS-232 Control
9.1. RS-232 Connection
According the RS-232 control mode, there are three types of RS-232 connection for
different application.
1. To control the switcher from local, please connect a control device (e.g. PC) to the
RS-232 port of the switcher.
2. To control the switcher from remote, please connect a control device (e.g. PC) to
the RS-232 port of the remote receiver.
3. To control the far-end third party device, please connect the control device (e.g.
PC) to the RS-232 port of the switcher, and then please connect the third-party
device (e.g. projector) to the RS-232 port of remote receiver.
9.2. RS-232 Control
After devices are connected accordingly to the RS-232 connection diagram, VEO-
XWT44E can be controlled by a PC (using serial terminal software) or by a third party
control system.
Please set the correct COM number on your PC or control system and baud rate, data bit,
stop bit and parity bit as follows:
Baud rate: 9600.
Data bit: 8.
Stop bit: 1.
Parity bit: none.
With these parameters it will be possible to communicate with the VEO device and
send the commands listed in the next chapter.
Bekijk gratis de handleiding van Ecler VEO-XWT44E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ecler |
| Model | VEO-XWT44E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2473 MB |
