DVDO -Splitter-12-CAT handleiding
Handleiding
Je bekijkt pagina 10 van 14
8 / 11
7. ASCII Commands
DVDO-Splitter-12-CAT also supports ASCII command control. Connect the
SERVICE port of the unit to a PC with a USB cable. Then, open a Serial
Command tool on a PC to send ASCII commands to control the unit.
Below is the list of ASCII commands for DVDO-Splitter-12-CAT:
ASCII Commands
Serial port protocol. Baud rate: 115200 (default), Data bits: 8bit, Stop bits:1, Check bit: 0
x - Parameter 1
y - Parameter 2
! - Delimiter
Command Code
Function Description
Example
Feedback
Default Setting
Power
s power z!
Power on/off the device,z=0~1
(z=0 power off, z=1 power on)
s power 1!
Power on
System Initializing...
Initialization Finished!
FW version x.xx.xx
power on
r power!
Get current power state
r power!
power on/power off
s reboot!
Reboot the device
s reboot!
reboot
System Setup
help!
List all commands
help!
r type!
Get device model
r type!
r status!
Get device current status
r status!
Get the unit all status:
power,
in/out connection,
edid mode
r fw version!
Get Firmware version
r fw version!
MCU BOOT: Vx.xx.xx
MCU APP: Vx.xx.xx
r link in!
Get the connection status of
the input port
r link in!
HDMI IN: connect
r link out y!
Get the connection status of
the y output port,
y=0~2 (0=all, 1~2=CAT 1~2)
r link out 1!
CAT OUT1: connect
r link loop out y!
Get the connection status of
the y loop output port, y=1
r link loop out 1!
HDMI LOOP OUT:
connect
s reset!
Reset to factory defaults
s reset!
Reset to factory
defaults
System Initializing...
Initialization Finished!
FW version x.xx.xx
Bekijk gratis de handleiding van DVDO -Splitter-12-CAT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DVDO |
| Model | -Splitter-12-CAT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1333 MB |
