DVDO -Matrix-44 handleiding
Handleiding
Je bekijkt pagina 18 van 24
16 / 21
8. RS-232 Control Commands
The Matrix can also be controlled by RS-232 command. Connect the RS-232
port of Matrix to a PC with serial cables, and open a Serial Command tool
(such as Comm Operator, Docklight or hercules, etc.) on the PC to send
ASCII command to control the Matrix. The connection diagram is as follows.
Baud rate: 115200 (default)
PC
Figure 1: 3-pin phoenix connector to USB
Important Notes:
1. All commands sent to the Matrix must be terminated with an exclamation
mark (!). Any carriage return that is present after the end of the
command will be ignored.
2. All spaces shown in the commands are required.
3. All response messages are terminated with a CR/LF sequence.
4. When all four inputs are requested by the same command, the response
will report each input on a separate line.
5. When four outputs are requested by the same command, the response
will report each output on a separate line.
CONTROL
TX RX
Data bits: 8
Parity: None
TCP/IP RS-232 IR EXT
Stop bits: 1
TX
Goun d
RX
3-pin Phoenix Connector
RS-232
RS-232 to USB cable
Bekijk gratis de handleiding van DVDO -Matrix-44, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | DVDO |
| Model | -Matrix-44 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2050 MB |
